As we all know,
Galletto 1260 is OBDII EOBD ECU Flashing
Cable which supports read and write
flash/eprom dumps of the most recent ECUs. Galletto 1260 have strong function
and support multi vehicle, but there are some people may have no idea about how to program the VAG diesel cars by using
Galletto 1260 ECU Flashing Cable ,bellow obd2repair will show you the detail steps .
- Buy a Galletto 1260 / 1250 lead.
- Load the software onto your fully charged computer.
- Plug the lead into the car (just above the ashtray).
- Open the software.
- Select the correct driver (see screen shot below).
Turn on the ignition and click
"ECU Data".
This will provide the ECU part number etc (below).
This will provide the ECU part number etc (below).
This part number is used for purchasing a
map so please make a note of it.
Select "Read ECU" save the
file with the extension .bin (example = original file.bin)
Once you click ok it will start reading
the ECU map, if your car fails to read with a seedkey error, remove fuses 11
and 15 which will turn off the dash.
After the ECU is read it will ask you to turn off the ignition.
After the ECU is read it will ask you to turn off the ignition.
Do the above as many times as you wish
until your confident.
Buy a map from my site, it will automatically send the file to your email address you pay my website.
Please note that the the file extension is .mod, some computers think this is a movie file but don't worry. It is the correct extension for Galetto.
Buy a map from my site, it will automatically send the file to your email address you pay my website.
Please note that the the file extension is .mod, some computers think this is a movie file but don't worry. It is the correct extension for Galetto.
Click "Open file"
Select the file from my website.
Press OK
Turn on the ignition (be aware for the fuel pump noise if you have removed the fuses for the dash)
Get comfortable, don't open/ close doors. make sure the laptop is stable (internet, antivirus and unused applications should be turned off)
Select "Download File"
Breath in and out for the next 90 seconds (This is the bit people forget)
Select the file from my website.
Press OK
Turn on the ignition (be aware for the fuel pump noise if you have removed the fuses for the dash)
Get comfortable, don't open/ close doors. make sure the laptop is stable (internet, antivirus and unused applications should be turned off)
Select "Download File"
Breath in and out for the next 90 seconds (This is the bit people forget)
When prompted turn off the ignition for 5
seconds
When prompted turn on the ignition
When prompted turn on the ignition
Enjoy your new performance!!!!!!!!
If you removed the fuses, put them back in
and expect an airbag warning. This warning is due to the fact the airbag
controller could not communicate with the dash once reset it will be gone for
good.
This
article is compiled by www OBD2repair com, if you have any advice on it, pls
feel free to contact OBD2repair - China OBD2 repair Tool Automotive Diagnostic
Tools Car Key Programmer OBD2 ECU chip tuning tool Center.
ADD:1102A,DongMing
Business Bldg, Longhua new district,
Shenzhen 518113,China
TEL
:+86-755-29438109
Email: sales03@eobdtool.com
Skype: eobdtool004
Website: www.obd2repair.com
0 comments:
Post a Comment