The most fascinating
function of Galletto 1260 EOBD2 Flasher is that it can achieve to read and
write flash/eprom dumps of the most recent ECUs. Well, we have shared the steps
of writing with galletto 1260 ecu flasher cable some time ago. Bellow OBD2repair
will share you the steps of how to read the ECU with galletto 1260 ecu flashercable.
How to write to
the ECU：
Writing the
remapped file is very similar except you would use open file rather than read
file.
1. Prior to
connecting the Galletto 1260 you must copy the software from the mini disc and
add it tothe desktop on
your laptop.
2. To use the
software, connect the USB end of the Galletto 1260 into the laptop.
3. Connect the
OBD lead to the cars diagnostics port. This is usually beneath the steering
wheel inthe fuse
compartment.
4. Open the
program named 'New Serial'. Wait 30 seconds.
5. Switch on the
ignition key to two clicks, don't start the engine.
6. Select
Peugeot/Citroen, Bosch EDC 15 C2 29f400BT.
7. Select ECU
data.
8. Select 'Open
file', and then select the new remapped file.
9. Select
download file. Make sure there is no other software running and no possible
interruptions,
don't knock the cable etc...
10. Afterwards,
when it prompts, switch off the ignition once the lift pump has stopped. Then
press ok and wait ten
seconds.
This article is
compiled by www OBD2repair com, if you have any advice on it, pls feel free to
contact OBD2repair - China OBD2 repair Tool Automotive Diagnostic Tools Car Key
Programmer OBD2 ECU chip tuning tool Center.
ADD:1102A,DongMing
Business Bldg, Longhua new district,
Shenzhen 518113,China
TEL
:+86-755-29438109
Email: sales03@eobdtool.com
Skype: eobdtool004
Website: www.obd2repair.com
0 comments:
Post a Comment